Round Acrylic Rod #8

[Mark90001]

$3.50 Per 6 inches plus shipping

G6: 13,7,7,7 inches
E5: 27,13,13,11 inches
C3: Sold
D8: Sold
F2: 19,14,10,6 inches
A7: 14,14,15 inches
D6: 10,7,7 inches
D10: 13,7,8,8 inches

I Can cut to any length
Measurements are approximate.

 

[MikeinSC]

All of C3 and D8 please. I'll send you a PM

 

[Sprsbux2]

Could I get all of the F2? By my calculations it should be around $30+ - with shipping? I just did my 1st purchase the other day for some bog oak,so you'll have to tell me what you need from me...

 

[Mark90001]

Could I get all of the F2? By my calculations it should be around $30+ - with shipping? I just did my 1st purchase the other day for some bog oak,so you'll have to tell me what you need from me...

I sent you a PM with total and shipping information.
Thank you,
Steven

 

[NT_2112]

Hi Steven. Just curious what the original raw components of this are. I was asked about the material in this thread.

Please review and offer feedback regarding threading and tapping issue

Hi all. This is a great site for a newbie like me, a big thank you to all the members. I'm running into an issue joining a kitless pen cap and a pen body. I made my own mandrel, as shown below. I plan to use it to hold the pen body and pen cap when I shape them on the lathe. I used a...

www.penturners.org

Thanks.

Regards,
Harry

 

[Mark90001]

Hi Steven. Just curious what the original raw components of this are. I was asked about the material in this thread.

Please review and offer feedback regarding threading and tapping issue

Hi all. This is a great site for a newbie like me, a big thank you to all the members. I'm running into an issue joining a kitless pen cap and a pen body. I made my own mandrel, as shown below. I plan to use it to hold the pen body and pen cap when I shape them on the lathe. I used a...

www.penturners.org

Thanks.

Regards,
Harry

I believe everything we purchased is acrylic acetate. Hope this helps.
Steven

 

[Mark90001]

Hi Steven. Just curious what the original raw components of this are. I was asked about the material in this thread.

Please review and offer feedback regarding threading and tapping issue

Hi all. This is a great site for a newbie like me, a big thank you to all the members. I'm running into an issue joining a kitless pen cap and a pen body. I made my own mandrel, as shown below. I plan to use it to hold the pen body and pen cap when I shape them on the lathe. I used a...

www.penturners.org

Thanks.

Regards,
Harry

Sorry don't know if my first reply was sent. The material is acrylic acetate. Hope this helps.
Steven