PreacherJon
Member
Mother's Day Proto Type 1
I'm going to make our church Mother's Day presents again this year. A suggestion from one of the ladies was a small ring bowl. Just size enough to put their rings in as night on a dresser.
With some scrap Maple, I made this - Not pictured is the bottom- A very small mortise about 1 1/8" and about 1/8" deep. I think I'll be able to mass-produce it. This is 3 3/4" and 1 1/4" My wife thinks I should shoot for 4 1/2".
Any suggestions? I'm thinking of just using some paste wax for a finish... so I can just apply it while it is on the lathe.
I'm going to make our church Mother's Day presents again this year. A suggestion from one of the ladies was a small ring bowl. Just size enough to put their rings in as night on a dresser.
With some scrap Maple, I made this - Not pictured is the bottom- A very small mortise about 1 1/8" and about 1/8" deep. I think I'll be able to mass-produce it. This is 3 3/4" and 1 1/4" My wife thinks I should shoot for 4 1/2".
Any suggestions? I'm thinking of just using some paste wax for a finish... so I can just apply it while it is on the lathe.