Saw came in earlier than expected. Finished squaring it up and quite satisfied with it. Comes with .333 saw blade 8.45mm measured.
Pros - Saw blade tension release, tool holder, cutting ability, quality of build. Ran some hard maple thru didnt bog down. Resawed 4 -1/2" x 3/4 pine, but motor handled easily. I plan on doing some resawing and am looking to pick-up a 1/2 resaw blade, the stock blade cut but I had .030-040 taper.
Cons- Fence is ok still undecided. I removed two delrin or nylon pads to be able to get the lockdown handle snap in. Video online guy contacted service regarding and they sent him couple new pads shorter in height. Im content with removing them, as of yet I see no issue doing it this way. Still learning the machine. I wish they would have ground the table sides square, they are off to each other and cant be used as a reference point.
Misc- Fence in resaw position lines up with the 0 line on tape and can be used to ballpark cut width. When fence is in lower position I couldnt find a position that would line up with the 0 line
Overall I'd buy again. For my use it works I wont be using it everyday or in a production environment.