Signguy
Member
I make a pretty wide variety of kits, so it's not really practical to keep 20-40 different replacement tubes on hand for the occasional bad outcome.
I'd like to just buy some lengths of the brass tubing in each of the common outer diameters and cut off lengths as appropriate when needed.
However, the thought occurred to me that perhaps there is variance in ID as well as OD, and if so this wouldn't work.
Can anyone tell me if this is (or is not) the case?
Thanks!
I'd like to just buy some lengths of the brass tubing in each of the common outer diameters and cut off lengths as appropriate when needed.
However, the thought occurred to me that perhaps there is variance in ID as well as OD, and if so this wouldn't work.
Can anyone tell me if this is (or is not) the case?
Thanks!