Wct3
Member
The trustone pen I posted last week wasn't the first blank-- I drilled too far with a brad point drill and blew off about 3/4 inch on the end. Not wishing to waste a blank, I started looking for another 8 mm set to use with a modified blank. I figure I can use some combination of the extra end pieces with some aluminum to make a feature of the pieced blank. Noticeably, however, there aren't a lot of 8 mm pen sets. I'm thinking I need to drill out the hole to a larger size, but boy that sounds risky!
Any suggestions and experience from anyone to help with this project? Thanks...
Any suggestions and experience from anyone to help with this project? Thanks...