Snowbeast
Member
Probably already been done but I haven't seen one yet.
After making a bunch of antler bullet pens for an upcoming gun show, I had a rather large pile of antler shavings and wondered what they would look like cast in clear PR.
Apparently this is the answer to that question. I don't think it looks too bad but there quite a few issues I need to work on next time. Ended up with waaaay too many air bubbles and less antler pieces than I anticipated. Should be relatively easy to fix, though. (I know. Don't bring the relatives into this.):biggrin:
Best part is, it doesn't smell like antler being turned!
Comments and critiques welcomed, as always.
After making a bunch of antler bullet pens for an upcoming gun show, I had a rather large pile of antler shavings and wondered what they would look like cast in clear PR.
Apparently this is the answer to that question. I don't think it looks too bad but there quite a few issues I need to work on next time. Ended up with waaaay too many air bubbles and less antler pieces than I anticipated. Should be relatively easy to fix, though. (I know. Don't bring the relatives into this.):biggrin:
Best part is, it doesn't smell like antler being turned!
Comments and critiques welcomed, as always.