Dale Allen
Member
I need to cut a slot in multiple pieces of acrylic sheet(plexiglas).
The cut will be half way through a 1" wide strip about 8 inches long, 1/2" deep on the 1" direction.
I was thinking of stacking about 3 or 4 of them and putting a thin piece of plywood on top, then run them on edge through the table saw backed up against the fence of my cutoff sled.
Am I asking for trouble?
My main concern is that the cut will not be a through cut and the top of the blade may melt the plastic.
The cut will be half way through a 1" wide strip about 8 inches long, 1/2" deep on the 1" direction.
I was thinking of stacking about 3 or 4 of them and putting a thin piece of plywood on top, then run them on edge through the table saw backed up against the fence of my cutoff sled.
Am I asking for trouble?
My main concern is that the cut will not be a through cut and the top of the blade may melt the plastic.