Drcal
Member
Has anyone used the new PSI Lathe Trimming Bit/ I could not find a thread with any comments.
Any info would help.
Thanks.
Carmen
Tampa Bay
Any info would help.
Thanks.
Carmen
Tampa Bay
Has anyone used the new PSI Lathe Trimming Bit/ I could not find a thread with any comments.
Any info would help.
Thanks.
Carmen
Tampa Bay
I think you could use a standard Forstner bit. It would leave a small dimple in the end of the blank to mark the exact center point for the drill bit. Forstner bits are not designed to drill into end grain, they are make to drill face grain. Not sure how it would work on acrylic.
This doesn't look like it would fit on either of my lathes. They both have mt2 tailstocks.