VotTak
Member
Hi there,
I am very new to this hobby, so sorry for this question.
While I'm trimming blank with tube I use 7mm Basic Barrel Trimmer: Steel Cutter from PSI. It works fine but there is a small piece of brass which is not being trimmed. Is there some tool to remove that excess? Currently I'm trying to remove it by using drill bit or knife, but it should be something better.
Thanks.
I am very new to this hobby, so sorry for this question.
While I'm trimming blank with tube I use 7mm Basic Barrel Trimmer: Steel Cutter from PSI. It works fine but there is a small piece of brass which is not being trimmed. Is there some tool to remove that excess? Currently I'm trying to remove it by using drill bit or knife, but it should be something better.
Thanks.