CSue
Local Chapter Leader
Well, I decided to take the bull by the horns, so to speak, and deliberately make a pen wood with Polymer Clay design elements. So this is a Birdseye Maple with Blue, Turquoise and light green PC spot design. The individual colors slowly swirl around from top of the pen to the bottom. I rounded the blank then drilled the holes. The Sculpey mixtures were packed into the holes with the tube in then baked 275 degrees 45 minutes. There was no problem with turning wood/clay mix. The PC didn't shrink. And I (accidentally) dropped one of the blanks on the floor - nothing came out. :redface:
So I would love your thoughts and comments.
So I would love your thoughts and comments.