JRowan
Member
I have been using Titebond Poly Glue for gluing the tubes into the blanks. As anyone who has used this or Gorilla Glue knows this stuff foams everywhere. When you go to trim the ends of the blanks with your mill, the foam inside makes it a bear to get the guide for the mill to go into.
I found that if you push an awl through the tube to open it up a little bit the best thing to clean up any foam that is stuck inside is a bronze bore cleaning brush for a rifle. I happened to have one for a 243 and if fit just right and cleaned up everything easily when chucked into a cordless drill.
Hope this helps.
I found that if you push an awl through the tube to open it up a little bit the best thing to clean up any foam that is stuck inside is a bronze bore cleaning brush for a rifle. I happened to have one for a 243 and if fit just right and cleaned up everything easily when chucked into a cordless drill.
Hope this helps.