SteveAxelrod
Member
Something in this red-dyed maple burl wasn't compatible with CA glue and after sanding it down twice and using my normal CA finishing method I gave up and decided to try dipping it in water based polyurethane which is a technique shared by rd_ab_penman. I diluted the poly about 10% with water and the dipping and blotting was simple enough. I waited a day between coats but probably could have done them sooner. The finish is smooth and glossy. I didn't follow Les's advice to sand the barrel down to make up for the extra thickness of the finish and as a result it's a tad too thick and it's noticeable at the ends.
I'll be trying this again and will compensate for the thicker finish.
View in Gallery
View in Gallery
View in Gallery
I'll be trying this again and will compensate for the thicker finish.
View in Gallery
View in Gallery
View in Gallery