robutacion
Member
I think this is the first time I make a thread under this "section" and after looking for the best place, I still think that, this is the best place as the issue goes from a hint, a trick and a wonderful and easy way to deal with those very tiny little holes, cracks, flaws that, most of the pen turn common tools seem to be always too big and therefore, creates a mess that takes more time and effort to clean up, making a very simple repair/filling, become a nightmare, sometimes...!
So, and before I spill my own beans on this one, I would like to hear what all of you do to fill those pinhead holes that normally become most obvious when you are trying to do the CA finish. Tell me, what "instruments" you use to handle such a miniature hole...???
More specifically, what CA applicator you use to allow you the control of the amount of CA that goes into the area in repair...???
This is not one of my games but, I may share some of what I use to solve this problem and "gift" them to the person that I feel deserves the most...!
Cheers
George
So, and before I spill my own beans on this one, I would like to hear what all of you do to fill those pinhead holes that normally become most obvious when you are trying to do the CA finish. Tell me, what "instruments" you use to handle such a miniature hole...???
More specifically, what CA applicator you use to allow you the control of the amount of CA that goes into the area in repair...???
This is not one of my games but, I may share some of what I use to solve this problem and "gift" them to the person that I feel deserves the most...!
Cheers
George