pgfitzgerald
Member
Hey everyone,
I badly scratched the tip on a slimline when I assembled it tonight. I'm going to pick up a transfer punch set from HF tomorrow so I can replace the damaged tip.
Just to make sure I don't screw it up...
I use a small diameter punch through the twist mechanism to knock out the tip? Then use a larger diameter punch from the tip end to knock out the twist mechanism? Also, can the twist mechanism be reused or should I just use a new one?
Thanks!
Paul
I badly scratched the tip on a slimline when I assembled it tonight. I'm going to pick up a transfer punch set from HF tomorrow so I can replace the damaged tip.
Just to make sure I don't screw it up...
I use a small diameter punch through the twist mechanism to knock out the tip? Then use a larger diameter punch from the tip end to knock out the twist mechanism? Also, can the twist mechanism be reused or should I just use a new one?
Thanks!
Paul