Pen assembly help.

Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
As woodchopper said, it would be ideal to know that kit. But if for a slimline, for example, the twist mechanism has a small indentation just above where the brass and steel meet. That's typically right around the sweet spot, but I always stop before and check - you can always press it in farther, a lot harder if you push too far and have to dissemble and try again. You just want to make sure that the pen refill fully retracts under the tip when not in use.
 
Take a look at some photographs showing how far the tip extends. Once you have done a couple you will know what looks right. It doesnt really matter which kit, though I'm assuming that it is a Slimline type. The indentations are just a rough guideline.
 
They are PSI pen kits, I've made a couple of the Foot Prints In The Sand and a couple of the Designer NT pens.

I was mostly having trouble with the designer pen from PSI, it said to leave 13/16" of the twist mechanism exposed. I inserted exactly 13/16" as stated but the writing tip did not stick out far enough from the tip, I ended up pressing the twist mechanisms in just a smidget more and everything work fine.

Thanks everyone!
 
Wood Knot said:
They are PSI pen kits, I've made a couple of the Foot Prints In The Sand and a couple of the Designer NT pens.

I was mostly having trouble with the designer pen from PSI, it said to leave 13/16" of the twist mechanism exposed. I inserted exactly 13/16" as stated but the writing tip did not stick out far enough from the tip, I ended up pressing the twist mechanisms in just a smidget more and everything work fine.

Thanks everyone!
Click to expand...
There can be a slight variation in the tube lengths .....barrel trimming for example, can slightly shorten the length of the tube.
As stated previously, just use the transmission marks as a rough guideline......as you now have done.
 
You must log in or register to reply here.
Back
Top Bottom