Panache pen dimensions

[BradG]

Hi Chaps
Would anyone happen to have a Panache pen they could measure for me?

I would like to know the outside width of the bushings, along with the length of the tubes

Thanks guys

 

[its_virgil]

This is easier...look on page 8 or 9
http://content.penturners.org/library/general_reference/bushingsandtubes.pdf

Do a good turn daily!
Don

Hi Chaps
Would anyone happen to have a Panache pen they could measure for me?

I would like to know the outside width of the bushings, along with the length of the tubes

Thanks guys

 

[Mack C.]

I will measure for you if you prefer!

 

[Monty]

You can find the bushing diameters here. I'll check the tube length when I get out to the shop later this morning.

 

[Mack C.]

Hi Chaps
Would anyone happen to have a Panache pen they could measure for me?

I would like to know the outside width of the bushings, along with the length of the tubes

Thanks guys

Short tube = 2.0155 in.
Long tube = 2.0495 in.

Large bushing on instructions shows .788, I measure the base to be .8080.

Other end bushing shown as .670, I measure the cap to be .6930.

Middle bushing shown as .570, I measure the Trim Ring to be .5720, and the cap coupler to be .5675.

 

[BradG]

Don, thanks for the link that looks mighty handy to keep on file.

Monty thanks for contributing,

Mack, nothing beats an actual measurement! Thanks for taking the time to do that, ive now drawn out my design to scale using your dimensions.

 

[Culprit]

...ive now drawn out my design to scale using your dimensions.

I made my first Panache last month and am enjoying using it daily at work. I'm looking forward to seeing what you come up with on this platform... <waits patiently>...

 

[walshjp17]

I have one queued up -- The Dinero version from WoodenPenPro in Hawaii. Can't wait until I can turn it. Has symbols from the US $1.00 bill on the finials.

 

[BradG]

...ive now drawn out my design to scale using your dimensions.

I made my first Panache last month and am enjoying using it daily at work. I'm looking forward to seeing what you come up with on this platform... <waits patiently>...

Certainly wont be an overnight job. I "think" i have the design down.. though building it will take me a little longer than the average pen im sure.

 

[BradG]

I have one queued up -- The Dinero version from WoodenPenPro in Hawaii. Can't wait until I can turn it. Has symbols from the US $1.00 bill on the finials.

Sounds good John, look forward to seeing it on SOYP