wfsteadman
Member
OK folks I hope you are all having a GREAT SATURDAY!!!!!
I am about to turn a translucent acrylic 7mm Faith Hope and Love pen and it has a 7mm tube. If I use a 7mm drill then paint the inside of the blank I assume it will be a tight fit, if it fits at all. What is the general rule of thumb for drill bit size when painting the inside of the blanks? Needing guidance on this one please.
Would I use maybe a 9/32 drill bit, as that would make it 7.1438 mm?
I am about to turn a translucent acrylic 7mm Faith Hope and Love pen and it has a 7mm tube. If I use a 7mm drill then paint the inside of the blank I assume it will be a tight fit, if it fits at all. What is the general rule of thumb for drill bit size when painting the inside of the blanks? Needing guidance on this one please.
Would I use maybe a 9/32 drill bit, as that would make it 7.1438 mm?
Last edited: