George Watkins
Member
Hello folks
here is two little hollow forms that I made yesterday, they were cut from the same log.
3" wide 4 1/2" tall
2 3/4" wide by 4" tall
this pic shows the initial shaping of the exterior and also this is the point i stop and hollow out the inside down to around 3/4 depth
this pic shows the form ready to sand
the smaller of the two forms finished and sitting ontop of the lathe
here is two little hollow forms that I made yesterday, they were cut from the same log.
3" wide 4 1/2" tall
2 3/4" wide by 4" tall
this pic shows the initial shaping of the exterior and also this is the point i stop and hollow out the inside down to around 3/4 depth
this pic shows the form ready to sand
the smaller of the two forms finished and sitting ontop of the lathe