NOVA DVR XP PROBLEM.....NEED HELP

[wizical]

hey everyone,

I ran into a bit of trouble with my lathe today, I turned it on, then it shut off.

it said on the readout, "Hardware Fault"
and also on the LCD it said "Low Voltage"

I dont know what caused this to occur. I want to know if anyone else has ran into this sort of problem and what steps were taken to fix it. thanks

 

[PenWorks]

Contact Tim Geist (304) 295-8166 he is the warrenty repair guy in the USA

I have not encountered that problem on mine

 

[Ligget]

I have not had that problem on mine either, but I here there real quick at helping to sort the problem.

I do not use the toggle on/off switch to turn my dvr off, I use the switch at the wall where its plugged in, when I switch it off that way it always says Low Voltage before finaly going blank.

Just my 2cents or 1penny as it were!

Keep us updated please.

 

[avbill]

I do not have your model lathe-- but could it be possible that the lathe is wired for 220V.

Bill Daniels

 

[Dario]

Did you reset your circuit breakers? Try that first.

 

[scroller99]

I had my dvr act grazy and had to take the back off and clean the pick ups on the shaft of the motor, it would stutter and then stop completely, just a shot of air to the pickups and the problem was cured, hope this helps Howard

 

[wizical]

i can definitely try that......thanks