Norfolk Island Pine

Signed-In Members Don't See This Ad
wood128

wood128

Member
Joined
Sep 16, 2006
Messages
1,677
Location
Cocoa Beach, Fl, USA.
What is the market today for NIP ? I have not seen any for sale . I have access to 3 trees which have been cut recently but they spalt fast in this Florida climate . Any interest from the woodturners ? These pieces are not for sale yet .
IMG_0278.JPG
IMG_0281.JPG
IMG_0279.JPG
 
Signed-In Members Don't See This Ad
wood128 said:
How much would you purchase ?
Click to expand...
Probably a couple of boards worth. Basically, some 1 inch thick by "medium USPS box" size - so 1" x 8" x 11". That would probably be about 5 pieces or so.
A large flat rate box of 3" x 3" x 12"
A large flat rate box of 1.5" x 3" x 12"
A box that has some 1.75 " x 6 - 8" x 6 - 8" quarter sawn pieces these would need to be true quarter sawn, so no pith, but the center of the log, as to get the widest possible pieces without any pith where the growth rings are perpendicular to the face of each board. Essentially, pieces that would be good for plates. If you could get them 11 x 11 x 1.75 quarter sawn, that would be perfect, but 1.75 x 6 x 6 and up would be fine too.
 
Jarod888 said:
Probably a couple of boards worth. Basically, some 1 inch thick by "medium USPS box" size - so 1" x 8" x 11". That would probably be about 5 pieces or so.
A large flat rate box of 3" x 3" x 12"
A large flat rate box of 1.5" x 3" x 12"
A box that has some 1.75 " x 6 - 8" x 6 - 8" quarter sawn pieces these would need to be true quarter sawn, so no pith, but the center of the log, as to get the widest possible pieces without any pith where the growth rings are perpendicular to the face of each board. Essentially, pieces that would be good for plates. If you could get them 11 x 11 x 1.75 quarter sawn, that would be perfect, but 1.75 x 6 x 6 and up would be fine too.
Click to expand...
I would only sell the wood in log form., but can remove the bark
 
I think pine in general, regardless of genus, is not well received by turners, as it is known to be very 'gummy' and sappy, with not a lot of highlighting to make the work of turning it worth it, which might be why you see very little of it for turners. Great for flat work or general construction once fully dried.

Kevin
 
You must log in or register to reply here.
Back
Top Bottom