Newbie from N. KY

Signed-In Members Don't See This Ad
J

j_a_wolfe

Member
Joined
Dec 15, 2012
Messages
4
Location
N.KY but subject to change
Hello all,

I've been lurking for a while and decided Santa Claus needed a boot in the pants and some better guidance. As a result, I have a new mini-lathe and a handful of sacrificial slimline pen kits.
I'm not incredibly bright but I'm not afraid of failure so I'll probably be back in a few hours with a bucketful of questions.

Jim
 
Signed-In Members Don't See This Ad
Joe S.

Joe S.

Member
Joined
Jan 11, 2012
Messages
2,000
Location
South Lyon, MI
Hi! Here is a tip: if it didn't turn out right, you don't need to put it on a kit! Just get extra tubes, this will eliminate stress, cost, ugly pens, and will put you in the mindset to always go for you best work on a pen. But you WILL end up with a pile of "learned on" tubes! :biggrin:
 
You must log in or register to reply here.
Previous Next
Top Bottom