So I mounted my negative rake carbide holder on the quick change tool post on my mini natal lathe. I wanted to test the concept for finish on some Acrylic cut offs. After rough cutting I made a few light passes with the negative rake carbide holder. The carbide is a $2 insert. The AA was not sanded at all. I only ran some Mequires auto polish on a paper towel. This has the potential of saving me much sanding. I would likely run thru the MM pads but the as turned finish is about 95% complete.
Danny
Sent from my iPhone using Penturners.org mobile app
Danny
Sent from my iPhone using Penturners.org mobile app