Need someone that can engrave the white logo in pic. Yes, I know it's trademarked. This is for my personal use. So Call the COPS!!! It's a Twisted Sister Logo. Need on 2 pieces of wood. Pretty close to exact location on both
Wanted Need someone to engrave wood
- Thread starter EBorraga
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Karl_99
Member
Stan Cook does very nice work. He is an IAP member.
Ill shoot him a message!!
Woodchipper
Member
Check with a local trophy shop.
MRDucks2
Member
I'll do it for free if you run to Texas and pick up the system I bought that has a laser. 
wolf creek knives
Member
I'll do it for free if you run to Texas and pick up the system I bought that has a laser.
Mike, if you don't mind me asking. What system did you buy that has the laser. I was just asked if I could put a company name on a handle and I don't have a clue as to what to look for. And I know there's a library on the site but I haven't found it yet. Thanks.
MRDucks2
Member
I bought the used X-carve that was up in Texas panhandle, then had my brother in law go pick it up and take it to his house outside of Dallas. Seller indicated it came with the Dewalt router and 2 laser heads. Only have photos so far and it will need a little work with a lot of research, but looks like it is supported by a huge community.