need part for bolt action pen

Signed-In Members Don't See This Ad
R

rebel1

Member
Joined
Feb 5, 2011
Messages
61
Location
richmond hill ga.
I need the small L shaped piece that screws into the top of the Gun Metal Bolt Action pen from Penn State. I have a gold one to swap or will buy from you. Penn State will only sell the whole top of the pen for $10.00 plus shipping. Thanks :smile:
 
Signed-In Members Don't See This Ad
Can you be more specific? Show a picture of the one you have. If you are talking about the "bolt" that moves in the slot, it does not screw in.

Ray
 
Post a pic of the part you need. I have two Gun Metal that are being used for parts. I most likely have what you need but need more info and a pic of it to be sure. If it is what I think, you can have it.

Chris
 
... or not actually the bolt, but the bolt lever which protrudes through the side of the pen to operate the bolt. It doesn't actually screw in, but is held in place by a screw inside the cap. You'll need a #0 phillips screwdriver to get that screw out.
 
robersonjr said:
The bolt, it does screw in, loosen the set screw and unscrew the bolt.
Click to expand...

Yes, it screws in and locked by a set screw accessible through the cap. The set screw jams against the threads of the bolt and is the weakest point. I have had 2 break. You have to get the full cap - the bolt is not sold as a replacement.
Timberbits has a Mk2 where the bolt is smaller and does not protrude as much as the PSI unit. It is not screwed but integral with the slider.
 
Stephen said:
robersonjr said:
The bolt, it does screw in, loosen the set screw and unscrew the bolt.
Click to expand...

Yes, it screws in and locked by a set screw accessible through the cap. The set screw jams against the threads of the bolt and is the weakest point. I have had 2 break. You have to get the full cap - the bolt is not sold as a replacement.
Timberbits has a Mk2 where the bolt is smaller and does not protrude as much as the PSI unit. It is not screwed but integral with the slider.
Click to expand...

Interesting because it looks identical to PSI on their website and PSI has a patent for their bolt action pen. I hope they obtained rights to sell their own.
 
Sawdust1825 said:
Stephen said:
robersonjr said:
The bolt, it does screw in, loosen the set screw and unscrew the bolt.
Click to expand...

Yes, it screws in and locked by a set screw accessible through the cap. The set screw jams against the threads of the bolt and is the weakest point. I have had 2 break. You have to get the full cap - the bolt is not sold as a replacement.
Timberbits has a Mk2 where the bolt is smaller and does not protrude as much as the PSI unit. It is not screwed but integral with the slider.
Click to expand...

Interesting because it looks identical to PSI on their website and PSI has a patent for their bolt action pen. I hope they obtained rights to sell their own.
Click to expand...
Timberbits won't sell it in the USA.
 
You must log in or register to reply here.
Back
Top Bottom