I went to a hobby shop with the intent of getting somw sheet brass and aluminum. They didnt have any aluminum but they did have tin so I got that instead.
I had asked a few people on this site about what they used and where they got it. As usual I got some excellent advise. I didnt think it would turn easily but to my surprise it does. I havent had any issues with blanks blowing up, just using thick ca to glue assemble them. Granted I take very small cuts with each pass for a couple reasons. ! I dont want the blanks to blow up & 2 I enjoy turning, the longer it takes the better in my opinion. If times were not so tough and I had the extra cash to go and order or pick up blanks and kits every week or so I might go faster but for now I guess I am just taking my time and having fun.
Thanks to you all for the warm welcome and comments.