diverdad
Member
I hope the picture comes out okay. The bottom pen is a piece of 2x4 cut and drilled, and stained with walnut. The top pen I did today from a pre-drilled Brazilian Rosewood blanks and a PSI slimline kit. I rubbed two coats of urethane on it and cut in some finger grooves.
I got those ideas from this forum, so thanks.
I also got my neighbor at the lathe and he made his first pen. You should have seen his face. He was so proud.
I have a long way to go and would appreciate any suggestions you may have.Thanks for looking.
Andy
I got those ideas from this forum, so thanks.
I also got my neighbor at the lathe and he made his first pen. You should have seen his face. He was so proud.
I have a long way to go and would appreciate any suggestions you may have.Thanks for looking.
Andy