My lathe takes MT1 - it's a late 80's/early 90's Craftsman. I received a PSI 3-wheel buffing setup as an early Christmas gift from my parents. The buffing setup is MT2, so I need an adapter so I can use it.
Looking for an adapter to fit in my MT1 headstock that will take a MT2 spindle. Attached is a picture of one I pulled off ebay.
Wondering if anyone has one laying around they'd be willing to sell or if anyone knows a place to get one for a good price.
The only place I've been able to find them so far is ebay, and they're running just about $30 shipped for one and am hoping to find one for less than that, if possible. There was one listed on ebay for a BIN price of about 1/3 of that, but I didn't get to it fast enough...
Looking for an adapter to fit in my MT1 headstock that will take a MT2 spindle. Attached is a picture of one I pulled off ebay.
Wondering if anyone has one laying around they'd be willing to sell or if anyone knows a place to get one for a good price.
The only place I've been able to find them so far is ebay, and they're running just about $30 shipped for one and am hoping to find one for less than that, if possible. There was one listed on ebay for a BIN price of about 1/3 of that, but I didn't get to it fast enough...