jttheclockman
Member
Had some time in the shop today.
Here are the blanks that I had started some time ago and were seen when I had shown the jig I used to make my feather cuts. I did 2 blanks. One on the left is a 60 degree cut and the one on the right is a 45 degree cut with a couple rings on the ends. Each is black acrylic and aluminum inlay. Both are Sierra Vista kits. I did the 2 cuts to show the difference in look and that either angle is just fine for these simple cuts. There is so much you can do with this simple cut. More to follow. As always any comments or questions are always welcomed. Thanks for looking.
Here are the blanks that I had started some time ago and were seen when I had shown the jig I used to make my feather cuts. I did 2 blanks. One on the left is a 60 degree cut and the one on the right is a 45 degree cut with a couple rings on the ends. Each is black acrylic and aluminum inlay. Both are Sierra Vista kits. I did the 2 cuts to show the difference in look and that either angle is just fine for these simple cuts. There is so much you can do with this simple cut. More to follow. As always any comments or questions are always welcomed. Thanks for looking.