knottyharry
Member
The next pic is of the pen blank at the end of the board. By moving the pen blank one way or the other will determine wher the kerfs are made. I didn't quite understand how Richard used the tape. But what I did was to use scotch tape across the top of the pen blank to hold it in place and I lined it up with the upper corner of the board.
With the end of the board against the fence, just slide the board straight into the blade. Now you are only cutting half way or about through the pen blank so lay something on the pen blank to hold it down.
Next pic is of the finished blank.
I'm sure i'm forgetting something, so if you want to know something just ask.
And thank Richard for his efforts on this, not me.
Harry
With the end of the board against the fence, just slide the board straight into the blade. Now you are only cutting half way or about through the pen blank so lay something on the pen blank to hold it down.
Next pic is of the finished blank.
I'm sure i'm forgetting something, so if you want to know something just ask.
And thank Richard for his efforts on this, not me.
Harry