Has any one had this problem? I needed a lighter wood for a person at her suggestion. Turned the blank down to bushing, sanded to 600, then went through the full micro mesh , wet sanding. The dye on the mm leaked out on to the blank and I got a blue-ish/purple-ish unknown color.
It actually looked good on gun metal pen, but I can not get any specific
light color blank now. These pads were from PSI. Do all mm pads leak a color or is it just this company? I will try to get a picture later.
It actually looked good on gun metal pen, but I can not get any specific
light color blank now. These pads were from PSI. Do all mm pads leak a color or is it just this company? I will try to get a picture later.