For those that have put a ribbon on a pen, what did you use to attach the ribbon to the tube? I am going to use 2 sided tape but dont know if the PR will weaken the tape. Any suggestions? Thanks.
I have casted Military camoflauge(BDU's) material and used CA to glue it to the tube. No pressure pot, just pour Silmar 41 directly onto ribbon. I also casted using another type of fabric using the same method and had the same results. I will say to be careful not to use too much CA so it doesnt seep thru the fabric, which could cause the discoloration.
Just an idea because I have looked at doing this. Could you print the ribbon on a acyrlic sheet, or perhaps regular paper than seal it first in plastic wrap of some sort? Again throwing out ideas that I have thought about. I was planning on trying to do this this summer. Ventilation in basement not good enough to do this.
Rick,
I know the issue ribbons and the ones from Vanguard will bleed if they get wet. You may want to try Scothguard to see if that will prevent the colors from running.Or maybe a couple light coats of spray laquer.