Woodlvr
Member
So I am trying to drill my blanks straight on my drill press ( dumb I know).
I have leveled and relevelled my PH vise and no matter what I do my eyeball can tell my drilling isn't straight. So I am measuring the sides (after drilling and without tubes installed) and my measurements differ by .015 from top to bottom am I being too OCD trying to not have out of round blanks? Or could it be my dumb Ridgid drill press? Thanks for any suggestions.
I have leveled and relevelled my PH vise and no matter what I do my eyeball can tell my drilling isn't straight. So I am measuring the sides (after drilling and without tubes installed) and my measurements differ by .015 from top to bottom am I being too OCD trying to not have out of round blanks? Or could it be my dumb Ridgid drill press? Thanks for any suggestions.