Casting Love these

Signed-In Members Don't See This Ad
Joined
Oct 22, 2012
Messages
24
Location
Casa Grande, AZ
Designed these in Fusion 360 with parametric dimensions so I can change angles and thicknesses with a few key strokes. Thanks Fred Wissen these printed with 3mm filament...
 

Attachments

  • 20180505_155916.jpg
    20180505_155916.jpg
    235.1 KB · Views: 344
Signed-In Members Don't See This Ad

Kenny Durrant

Member
Joined
Sep 11, 2012
Messages
2,480
Location
Sachse Tx. 75048
Those look very nice. How do you pour them? Do you tape off the channels you want to keep clean and do one at a time or are you steady enough to not spill the resin in the wrong hole?
 

robutacion

Member
Joined
Aug 6, 2009
Messages
6,514
Location
Australia - SA Adelaide Hills
Those look very nice. How do you pour them? Do you tape off the channels you want to keep clean and do one at a time or are you steady enough to not spill the resin in the wrong hole?

I'm not sure how he does it but if was me, I would be using a small funnel either plastic (cleanable) or make some out of craft board (disposable).:confused:

Cheers
George
 
Top Bottom