Clement Feme
Member
Put together four Longwood pens today. The kits werte from Pen State.
The blanks were round Predrilled Acrylic. The problem that I am having is that the transmission is extremely difficult to twist. I made sure that the top section is at least 3 in. plus a fraction. also the fit of the top barrell to the bottom section is really tight. The one inch part of the top section without the barrell was clean. Could there be a possibility that the predrilled blanks were drilled a fraction smaller. I had no problems Inserting the barrells.
Thanks for any thoughts
Clem
The blanks were round Predrilled Acrylic. The problem that I am having is that the transmission is extremely difficult to twist. I made sure that the top section is at least 3 in. plus a fraction. also the fit of the top barrell to the bottom section is really tight. The one inch part of the top section without the barrell was clean. Could there be a possibility that the predrilled blanks were drilled a fraction smaller. I had no problems Inserting the barrells.
Thanks for any thoughts
Clem