kenbu
Member
Newbie here, hoping for some advice. I'm making a click style pen for a friend and discovered the nice custom clip/logo sets sold by Hut products are made for the Euro style twist pen -- the clip mounting hole is small, appropriate for a screw-in end cap, but too small for other designs, like clickers. There is not enough metal to enlarge the hole.
The logo itself is a slightly domed button 10 mm in diameter. I thought I'd recess it into the pen barrel, but when I test fit it on a dowel using holes of varying depths, the button either stuck out or the hole seemed too obvious.
Any suggestions? Could I just epoxy it directly to the pen's stock clip and expect it to hold with regular use? Is there any reasonable way to mount something like this on the pen barrel? Other ideas?
I appreciate your suggestions.
Ken
The logo itself is a slightly domed button 10 mm in diameter. I thought I'd recess it into the pen barrel, but when I test fit it on a dowel using holes of varying depths, the button either stuck out or the hole seemed too obvious.
Any suggestions? Could I just epoxy it directly to the pen's stock clip and expect it to hold with regular use? Is there any reasonable way to mount something like this on the pen barrel? Other ideas?
I appreciate your suggestions.
Ken