ldb2000
Member
Hi All
This question is directed more to George (Texasdurango) but all are REQUIRED to chime in with ideas(hee hee ) .
I'm working on a PMC clip with Heavy Music wire as reinforcment and am wondering about Work hardening of the PMC to make it a little less brittle .
Has anyone had any luck with tumbling the clip for long periods of time to work harden the PMC as per the posts in the PMC guilds fourms .
Lets get some ideas going here about clips and the likes .
Also anyone casting any other kinds of low melting point metals for any other reasons that might be used for making clips and stuff .
This question is directed more to George (Texasdurango) but all are REQUIRED to chime in with ideas(hee hee ) .
I'm working on a PMC clip with Heavy Music wire as reinforcment and am wondering about Work hardening of the PMC to make it a little less brittle .
Has anyone had any luck with tumbling the clip for long periods of time to work harden the PMC as per the posts in the PMC guilds fourms .
Lets get some ideas going here about clips and the likes .
Also anyone casting any other kinds of low melting point metals for any other reasons that might be used for making clips and stuff .