Lathe parts

Signed-In Members Don't See This Ad

rizaydog

Member
Joined
Oct 1, 2010
Messages
1,741
Location
Wellsboro Pennsylvania
I have a TurncrafterPro Variable speed lathe Model # TCLPROVS. I took it to a demo over the weekend. The guys in my club used it on Saturday. When I came to the demo on Sunday, some parts were broken and the motor wasn't running. I need a new knock out bar, locking lever for the tool rest/ tail stock quill, and brushes for the motor. I sent an email to PSI but they never responded. Any ideas where I can get these parts?
 
Knowing what happen might give you a better path to start with. Did you include part numbers in your e-mail? Think your club should pick up cost of parts and repairs, or lathe replacement.

http://www.pennstateind.com/library/TCLPROVS_man2.pdf

Do you have a button can push on overload protector or around on off switch for motor? Doing electrical check on switch, overload protector and motor should help pin point why motor will not run.

You may be able to dissemble & clean tailstock quill to get operational again.

Not knowing thread size of handle/lever hard to recommend a place like Grainger, Mcmaster- Carr, unless have a place like that near you where can bring parts.
 
Back
Top Bottom