lorbay
Member
I have not done too many pens with ink jet labels on them and have not had good success on wood. I am putting a name on the pen and it seems I can always see the label in some light conditions. Here is how I do it.
Sand to 800
Apply 2 coats of ca
Sand with 800 again
Apply 1 more ca and then apply label (that has been sealed) let dry for 24
Then apply 10 to 15 ca
Then sand with 600 and them through all the MM pads.
Is this wrong.??
Lin
Sand to 800
Apply 2 coats of ca
Sand with 800 again
Apply 1 more ca and then apply label (that has been sealed) let dry for 24
Then apply 10 to 15 ca
Then sand with 600 and them through all the MM pads.
Is this wrong.??
Lin
Last edited: