Hi, just registered in hopes to find some help from some experts. i just started doing label casting using my own silicone molds and Alumilite Clear Slow. most of the blanks come out fine but occasionaly i get seperation between the tube and resin at eh ends. typicaly i can't see this untill the blank is almost finished
. Im not sure if this is being caused by the casting, appling to much pressure when trimming the blank, too much pressure when setting it up in the lathe or just the fact thar the resin is very thin due to the pen type and there is not much can be done? Pen is a Corporate
thanks
. Im not sure if this is being caused by the casting, appling to much pressure when trimming the blank, too much pressure when setting it up in the lathe or just the fact thar the resin is very thin due to the pen type and there is not much can be done? Pen is a Corporatethanks
