Jet mini lathe dust shrouds???

[Greg O'Sherwood]

This thread is in the indiv classifieds, there is a pic of a jet minilathe with a DC shroud.

http://www.penturners.org/forum/showthread.php?t=44637

I've done some searches, but can't locate a place that sells them. I don't see it on the Jet parent website, either. Did I just miss it, or is it an aftermarket product?

Can anyone provide a link to them?

 

[rjwolfe3]

PSI is where I got mine but I think quite a few places carry them. Mine is magnetic and has a shield that flips up with a 4" opening for the hose.

 

[Woodlvr]

Woodcraft carries them, we were always selling out of them.

 

[Tracker18]

Rockler has them.

 

[Greg O'Sherwood]

Jeez! Everyone has them! How the H - E - doublehockeysticks did I miss them???

Thanks for the help, guys

 

[Crayman]

Greg, If you get this, one thing I did was add a bottom panel extension made from some scrap plexiglass and velco. This stopped most of the larger piece from dropping down on the motor. When I don't need it for bowls or want it longer just adjust or remove it the bottom panel

 

[randyrls]

I've seen a pic of a Oneway or Powermatic lathe with a rod on the back side attached to a hose end. The rod is behind and parallel to the lathe axis. Just put a 4" DC hose end coupler with a small attachment to connect the rod to the hose end. Easily adjusted and simple.

 

[wdcav1952]

Jeez! Everyone has them! How the H - E - doublehockeysticks did I miss them???

Thanks for the help, guys

CA fumes?!?!?!?!? :biggrin::biggrin::biggrin:

 

[Greg O'Sherwood]

CA fumes?!?!?!?!? :biggrin::biggrin::biggrin:

Dang! You're probably right!
Why didn't I think of that?



oh, yeah... CA fumes...


:hypnotized: