tbfoto
Member
It's been a while since I've been able to get some shop time but I have my lathe set up and got a couple blanks out and glued in some tubes to make a slimline pen. However when using my barrel trimmer it leaves the tube raised above of the wood. Is that normal. Wood is Holly. Standard slimline kit with 7mm tubes. Using the correct barrel trimmer shaft.
Any suggestions, or is this correct? I don't remember it doing this before.
I thought the whole idea of the barrel trimmer was to cut everything smooth.
Any suggestions, or is this correct? I don't remember it doing this before.
I thought the whole idea of the barrel trimmer was to cut everything smooth.