Yes, I agree with Curly, a much better job/shape/size...!:biggrin:
I was thinking of this when I gave you my advice yesterday, I never did one of these pens and I wonder, to finish the refill nose to look as good/sharp as the one you've done, will it be prone to break the very ends if the person using the pen puts some pressure on the pen when writing..?? is the acrylic strong enough without a brass insert, one that would be just a tiny wider inner diameter than the refill end..?
This would off-course prevent the nose to be as "sharp" if the insert run right to the blank's end, as the brass wall diameter, would be at least 1/2 millimetre thick however, if left 5mm inside from the nose end, the insert would take any side pressure on the acrylic end, incurred while writing, still allowing the nose to be finished sharply as you did...?
I'm just thinking out loud, as I don't know that kit, these are just my observations based on what I've seen, I apologise if I'm wrong...!
Cheers
George