Tiger
Member
Transfer punches have been spoken about a lot in this forum. Anyone know how they can be marked so you know what diameter they are? They are made of hardened steel and some form of marking would be very useful.
mine are in a plastic block, that fits way too tight on the punches and has numbers so small they are almost unreadable. I mostly use the trial and error method, plus I use about 3 or 4 mostly and I remember about where they are in the block
Name them - Cigar , Slim , Sierra etc
Name them - Cigar , Slim , Sierra etc
Mine are still in the case but I am with Wyone. Use the largest that fits and be done with it. I know I am an amateur among pros but I only rarely need to disassemble and never considered it necessary to worry about size. Just grab what fits. Am I missing something here. I always am looking to learn.