I just got a used, new to me, Nova DVR XP

Signed-In Members Don't See This Ad

endacoz

Member
Joined
Feb 5, 2014
Messages
799
Location
Brookfield, NY
Anyone else using this lathe?

I'm shocked at the DVR motor and the power it has and how fast it notices when there's a load on it I can turn like I've never been able to turn before. Just got it last week started turning some handles and Christmas trees.
 

Attachments

  • 20261114_133651.jpg
    20261114_133651.jpg
    294.6 KB · Views: 38
  • 20261119_003007.jpg
    20261119_003007.jpg
    202.4 KB · Views: 37
  • Screenshot_20261117_231732_YouTube.jpg
    Screenshot_20261117_231732_YouTube.jpg
    175.1 KB · Views: 38
Signed-In Members Don't See This Ad
I have that exact lathe and love it! Below are suggestions. I would buy this lathe again. It is excellent quality and will last.

Dust tends to get inside the headstock and get into the speed control sensor. Remove red plate on headstock and blow out with compressed air.

The tailstock lock is small in diameter and tends to hurt my hands. I added a larger diameter wood handle that fits over the original shaft.

Addendum: Look for a bed extension. If you want to turn tool handles. The photo looks like it has the extension.
 
I have a couple of the older belt change Nova 3000 lathes. I have a 3 phase motor ready for one and will get a VFD to make it into a poor mans DVR. Nice thing about them is that you can still get parts including circuit boards in the unlikely event you need it. The bed extensions and outboard turning tool rest are available too and like all lathe accessories can seem expensive but add a great deal of versatility to the lathe. They also make a double ended morse taper alignment tool that makes realigning the head and tailstocks easy after turning with the headstock swivelled. Have fun with it.
 
Is my primary lathe - have had it for many years and it's been a reliable workhorse! As said already, be sure to keep the left facing end of the headstock with the red panel on it clean to keep dust out of the sensor. If you get unusual speed issues with the motor or funky error codes, you will need to disassemble the sensor assembly and give it a good cleaning. Fortunately, with a little care, this is rarely needed.

Also suggest you fully unplug it from power at the end of each session as the potential for damage from ground faults and other power line anomalies is there since the power switch on the headstock doesn't kill the full circuit and the circuit board in the headstock required to run the DVR motor is the weakest part of the whole lathe. Some people have reported issues with using it behind a GFCI, but I have not had that problem.

Enjoy your new purchase!!!

Kevin
 
Back
Top Bottom