Hybrid Magnetic Bit Holder

[Kdoc87]

I am always using this tool, so I decided to make a new handle for it. It is a magnetic precision bit holder with 32 interchangeable bits. I made the blank with Buckeye and Copper Alumilite. The holder was a press fit into an 8mm hole with some epoxy. I think I'll be making more tool handles!
Comments and/or critiques are welcome..Thanks for looking!

 

[GaryMGg]

Your seam is almost invisible in the middle pic. Nice.

 

[campzeke]

Good job. There is something special about using a tool you made yourself. It just feels good!

 

[magpens]

Yes, indeed !!! . That is very nice ! . Did you cast the handle material ? . And did you cannibalize the holder from another tool ?

 

[Kdoc87]

Thanks you for the responses! Yes I cast the Alumilite for the handle. The tool used to have a plastic yellow/orange handle that I removed. Here is a link to the tool - http://www.amazon.com/32-piece-PREC...=1462326551&sr=8-33&keywords=Mini+screwdriver

 

[Charlie_W]

Very nice Kevin! Sure beats that plastic handle that it came with!