I have a couple of questions on finishing with the Hut Crystal Coat. When I am sanding I start with 180-240-320-400-600, them MM w/12000. I usually touch the blanks on the lathe with the last two finest grits with some denatured alcholol and a t-shirt patch to take off the sanding powder that is left on the blanks. Then I use the Hut, which leads me to my two questions. I don't have a buffing wheel, I only finish it on the lathe. If I want a glossy appearance, I have use CA finish and that is a seperate issue that I am not addressing here.
1. How much "pressure" is used and will the "gloss" change with each wood as some come out with a gloss appearance and some (noticed burls) will come out with a "satin" finish. I have tried 2-4 coats and sometime my finish feels tacky.
2. Should I use a sanding sealer before the Hut?
1. How much "pressure" is used and will the "gloss" change with each wood as some come out with a gloss appearance and some (noticed burls) will come out with a "satin" finish. I have tried 2-4 coats and sometime my finish feels tacky.
2. Should I use a sanding sealer before the Hut?