I like that segmentation as well!
Is it possible to reorient the bolt after assembling the pen?
Sent from my iPhone using
Penturners.org mobile app
Yes Bob,
You remove the Nose Cone and Refill.
You need a Long Thin Shafted Phillips Screwdriver, that will fit through the Nib Cone Holder, and reach the Screw in the Bolt Mechanism.
You do not have to remove the screw just loosen it.
You can Rotate the Bolt Handle, through 180 deg.
Tighten the Screw with the Bolt Handle in the New Position.
Partial unscrew the Firing Cap, on the the Finial, disengage the Clip from it's Holding Slot, Rotate it though 180 deg, to the new Holding Slot, Push it into the slot by applying Pressure on the Clip Bend, when in it's position, Hold it while you Tighten the Firing Cap.
Refit the Refill and Nose Cone
Your Bolt will be Pointing Down, on the Right Hand Side, with the Clip on top of the Pen.
Hope this is adequate.
Brian.