ed4copies
Local Chapter Manager
This week I have had several inquiries about "facing" blanks. My instruction sheets refer to an "alternative" to pen mills, but there are no specifics, so I thought I would make this video to explain "Facing on the lathe with sandpaper".
Just one note, this is done after the pen is mostly turned, so that there is less material to remove, since sandpaper does not act quickly, just efficiently!!:biggrin::biggrin::biggrin:
Pen turning-facing on the lathe with sandpaper - YouTube
Comments and critiques are always appreciated!!
Ed
Just one note, this is done after the pen is mostly turned, so that there is less material to remove, since sandpaper does not act quickly, just efficiently!!:biggrin::biggrin::biggrin:
Pen turning-facing on the lathe with sandpaper - YouTube
Comments and critiques are always appreciated!!
Ed