Chasboy1
Member
Hi folks, I have a 'basic' dust collection/vacuum setup in my shop that uses a set of clear plastic tubes with a number of elbows and slide gates for attaching a vacuum hose. It's all supported by my shop vac in another room.
Over the years the clear plastic has dried out and the joints are not tight. I'd like to re-create it with PVC for the main runs but the problem is I cannot find a way to adapt PVC to 2 1/4 vacuum hose/fittings.
Has anyone found a way to get around this?
Thanks!
Over the years the clear plastic has dried out and the joints are not tight. I'd like to re-create it with PVC for the main runs but the problem is I cannot find a way to adapt PVC to 2 1/4 vacuum hose/fittings.
Has anyone found a way to get around this?
Thanks!