spaceengravers
Member
So I made my first bullet pen today. I'll post pics later in the 'show off' thread but I need some help. The 7mm tube didn't fit inside the bullet perfect at either end. So I remembered seeing a tutorial about soldering in the tube, but couldn't find it again for reference. Anyway, I glued in one end and soldered in the other but I couldn't figure out how to get the tube perfectly centered in the hole. So when it was complete the nib and upper barrel were slightly off-set from the lower barrel. Not too much but enough I won't try to sell it (when I start trying to sell them...) So how do I keep the tube centered in the bullet while it glues or is soldered?
Thanks for your help!
Mike
Thanks for your help!
Mike